Cisco Nexus 7000 Series Reference Guide

N Commands
ntp broadcast
291
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
ntp broadcast
To enable a Network Time Protocol (NTP) IPv4 broadcast server on the specified interface, use the ntp
broadcast command. To disable the NTP IPv4 broadcast server, use the no form of this command.
ntp broadcast [destination ip-address] [key key-id] [version number]
no ntp broadcast [destination ip-address] [key key-id] [version number]
Syntax Description
Defaults None
Command Modes Interface configuration mode (config-if)
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines Use NTP broadcast or multicast associations when time accuracy and reliability requirements are
modest, your network is localized, and the network has more than 20 clients. We recommend that you
use NTP broadcast or multicast associations in networks that have limited bandwidth, system memory,
or CPU resources.
Note Time accuracy is marginally reduced in NTP broadcast associations because information flows only one
way.
This command does not require a license.
Examples This example shows how to enable an NTP IPv4 broadcast server on the interface:
switch# configure terminal
switch(config)# interface ethernet 6/1
switch(config-if)# ntp broadcast destination 192.0.2.10
destination ip-address (Optional) Configures the broadcast destination IPv4 address.
key key-id (Optional) Configures the broadcast authentication key number. The range
is from 1 to 65535.
version number (Optional) Configures the NTP version. The range is from 2 to 4.
Release Modification
6.2(2) This command was introduced.

Cisco Nexus 7000 Series Specifications

General

Brand	Cisco
Model	Nexus 7000 Series
Category	Switch
Language	English