2.5.17 set-svc-route (gateway)
Description
Syntax: sc set-svc-route GATEWAY DESTNET
Alternative names: ---
Authorization level: None
A special network route can be entered using command "sc set-svc-route". A typical application
is to make a service network, connected via modem, accessible, e.g. for remote diagnostics.
The parameters are the GATEWAY, via which the packets for DESTNET should be routed.
The gateway must be specified with its IP address, and this must be located in a network that
is directly connected. The gateway must be able to be accessed without additional intermediate
routers.
NOTICE
Routing in the network
The target network, which should be applicable for the detour via GATEWAY, can be specified
in the usual syntax with network mask ("128.128.12.0/255.255.255.0") or CIDR
("128.128.12.0/24"). It is not permissible that it overlaps with one of the directly accessible
networks of the NCU - neither completely nor partially.
2.5.18 Show
Description
Various displays regarding the system state are summarized in command "sc show".
show ip
Syntax: sc show ip [-INTERFACE]
Alternative names: ----
Authorization level: None
This command displays the IP address data of network interfaces. You have the option to enter
a specific interface. If no particular interface is specified, the data for all existing interfaces is
displayed, as well as the Default Gateway.
Example:
sc show ip
X120 (system network, eth0):
configured: (default)
current : IP=192.168.214.1 Netmask=255.255.255.0
MAC=08:00:06:73:55:fd
DNS Name : ncu1.local
Configuring the system
2.5 Description of the actions
NCU operating system
56 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
