Backing up and restoring data
4.10 Starting Symantec Ghost directly
PCU-Basesoftware (IM8)
104 Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
Starting Symantec Ghost directly
With the "Symantec Ghost" software you can store the entire contents of an SSD as a disk
image. Disk images can be kept on various storage media for subsequent restoration of the
data on the SSD.
Symantec Ghost is supplied from the factory on replacement SSDs for the PCU and on the
SSD of the entire PCU. Symantec Ghost is used by the components of the PCU Base
Software to back up or restore data.
You can also start Symantec Ghost directly from the prompt to execute the data backup
tasks from the user interface of Ghost. This is necessary, for example, when using
CompactFlash cards.
To start Symantec Ghost directly, proceed as follows:
1. Call the prompt from the Service Center or the Service Desktop.
2. Enter "ghost.32.exe" and confirm the entry.
More information is available in the Internet on website Ghost.com (http://www.ghost.com).
To Next Page
Loading...
Need help?
General
