Detach the device from "sc usb status" using the port number:
# sc usb detach 00
Unexport device on the TCU:
# sc usb unexport TCU1 1-2.1
The device is no longer marked as exported:
# sc usb showdevs TCU1
0bf8:100c
2.5.21 vncpwd (password)
Description
The following actions are executed using command "sc vncpwd":
● sc vncpwd set to assign a password.
● sc vncpwd reset to delete a password.
Syntax: sc vncpwd set companynetwork|systemnetwork
sc vncpwd reset companynetwork|systemnetwork
Alternative names: ---
Authorization level: None
Using command "sc vncpwd set", on the server (NCU) a password is set up for the VNC
connection via the company network or the factory network. As soon as a password has been
assigned, a connection can only be established from an VNC client (TCU, Ultr@VNC, etc.) by
specifying the correct password.
Command sc vncpwd set always asks for a password to be entered.
Or, for example: sc vncpwd set systemnetwork secreT7+
Command sc vncpwd reset deletes the password for the specified network. A connection
in the network is therefore possible without authentication.
Note
Password in the network
In the network (factory network or company network), in order to access any server (NCU) in
the network from a TCU (client) via a VNC connection, all servers should use the same
password.
Configuring the system
2.5 Description of the actions
NCU operating system
62 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
