▷ In rest position: turn the switch downwards,
arrow 3. The switch returns to the park posi‐
tion when released.
▷ In intermittent mode: turn the switch further,
arrow 2. The switch returns to the intermit‐
tent position when released.
The function is deactivated if the washer fluid
level in the reservoir is low.
Fold-out position of the wipers
Principle
The wipers can be folded out from the wind‐
screen in the fold-out position. This is necessary
for example when replacing the wiper blades or
to keep them away from the windscreen when
there is frost.
Safety notes
WARNING
If the wipers start moving when they are folded
away from the windscreen, parts of the body
may become trapped or the vehicle may be
damaged. There is a risk of injury or material
damage. Make sure that the vehicle is switched
off when the wipers are folded away from the
windscreen, and that the wipers are in contact
with the windscreen when switching on.
NOTE
If the wipers are frozen to the windscreen,
switching them on may cause the wiper blades
to tear off and the wiper motor to overheat.
There is a risk of material damage. Defrost the
windscreen before switching on the wipers.
Folding out the wipers
1. Switch on standby state.
2. Press the wiper lever down and hold until the
wipers stop in an approximately vertical posi‐
tion.
3. Lift the wipers completely away from the
windscreen.
Folding in the wipers
1.
Fold the wipers fully down onto the wind‐
screen.
2. Switch on standby state and press and hold
the wiper lever down again.
The wipers move back to the rest position
and are operational once again.
Seite 152
CONTROLS
Driving
152
Online Edition for Part no. 01405A38CB9 - VI/21
To Next Page
Loading...
Need help?
General
