In vehicles without distance control: turn on the
Cruise Control with the buttons on the steering
wheel.
1. If necessary, press the button.
2. If necessary, press the button repeat‐
edly until the Cruise Control is selected.
Cruise Control is active. The driven speed is
maintained and stored as the set speed.
The indicator lights are illuminated in the instru‐
ment cluster and the marker in the speedometer
is positioned at the current speed.
When the Cruise Control is turned on, the drive
mode may change.
Turning the Cruise Control System
on/off
The Cruise Control System can be turned off or
cancelled automatically or manually.
For further information:
Cruise Control Systems, see page 227.
Setting the speed
To maintain/store the speed
Press the button in the interrupted state.
When the system is switched on, the current
speed is maintained and stored as the set speed.
The stored speed is displayed on the speedom‐
eter.
If necessary, the Dynamic Stability Control will be
turned on.
When Speed Limit Assist is not active, the cur‐
rent speed can also be stored by pressing a but‐
ton:
Press the button.
Changing the speed
Press the corresponding button until the
set speed is set.
If the system is active, the displayed
speed is stored and the vehicle adjusts to the
stored speed when the road is clear.
The maximum speed which can be set depends
on the vehicle.
Pressing the button to the resistance point and
holding it: vehicle accelerates or decelerates
without pressure on the accelerator pedal.
When the button is released, the speed is main‐
tained. Pressing beyond the resistance point ac‐
celerates the vehicle more rapidly.
Resuming Cruise Control
At the stored speed
If Cruise Control is interrupted, it can be resumed
by calling up the stored speed.
Before calling up the stored speed, make sure
that the difference between the current speed
and the stored speed is not too great. Otherwise,
there may be unintentional deceleration or accel‐
eration.
With the system interrupted, press the
button.
Cruise Control is resumed with the stored values.
In the following instances, the stored speed value
is deleted and therefore cannot be called up
again:
▷ When the system is switched off.
▷ When drive-ready state is switched off.
▷ When selecting another Cruise Control Sys‐
tem.
At the current speed
Press the button to continue Cruise Con‐
trol at the current speed.
Seite 232
CONTROLS
Driver assistance systems
232
Online Edition for Part no. 01405A38CB9 - VI/21
To Next Page
Loading...
