Removing the charging cable
General
During the charging process, the charging cable
is automatically locked. Unlock the charging ca‐
ble before removing.
Before removing, clean the area between the
charging socket flap and high-voltage charging
socket, for example to remove snow.
Removing a charging cable
1. Unlock vehicle or unlock charging cable via
iDrive.
The charging process is finished.
The charging cable is unlocked for a short
time.
2. Hold the charging cable at the grips.
3. Remove the charging cable from the high-
voltage charging socket, arrow.
4. Close the charging socket cover.
5. Press the charging socket flap closed until it
engages.
6. Where applicable, fit cover on charging cable
connector.
7. As applicable, disconnect the mode 2 charg‐
ing cable from the domestic socket outlet or
the mode 3 charging cable from the connec‐
tion point on the AC charging station.
8. Stow the charging cable if necessary.
At a charging station, insert the permanently
installed charging cable into the place provi‐
ded for this purpose.
Wheels and tyres
Tyre inflation pressure information
The tyre inflation pressure information can be
found on the tyre pressure label on the body pil‐
lar of the driver's door.
After adjusting the tyre inflation pressure
For the flat tyre monitor RPA:
Reinitialise the flat tyre monitor RPA.
For the Tyre Pressure Monitor:
The corrected tyre inflation pressures are applied
automatically. Make sure that the tyre settings
are correct.
For tyres that are not listed in the tyre inflation
pressure information on the control display, reset
the Tyre Pressure Monitor.
Checking the tyre inflation pressure
Check regularly and adjust as necessary:
▷ At least twice a month.
▷ Before a long journey.
Seite 41
On the move
QUICK REFERENCE
41
Online Edition for Part no. 01405A38CB9 - VI/21
To Next Page
Loading...
Need help?
General
