Warning function
Light in the exterior mirror
The light in the exterior mirror warns of a possi‐
ble collision.
Acute warning
If there is a risk of collision, the light in the exte‐
rior mirror flashes and the steering wheel starts
vibrating.
A Check Control message is displayed at the
same time.
Depending on the national-market version, if
necessary, an active steering intervention takes
place to prevent the collision and keep the vehi‐
cle in its own lane.
Steering intervention can be felt at the steering
wheel, and can be overridden manually at any
time.
System limits
Safety note
WARNING
The system may not respond at all, or may re‐
spond too late, incorrectly or without justifica‐
tion due to system limitations. There is a risk of
accident or material damage. Observe the in‐
formation on the system limits and intervene
actively if necessary.
System limits of the sensors
For further information:
▷ Camera, see page 48.
▷ Radar sensors, see page 49.
Functional limitations
The system may have restricted functionality in
situations such as the following:
▷ On sharp bends or narrow roads.
▷ When there are missing, worn, poorly visible,
merging/separating or ambiguous lane mark‐
ings, for example, in areas where there are
roadworks.
▷ With lane boundaries that are covered in
snow, ice, dirt or water.
▷ With lane boundaries that are not white.
▷ With lane boundaries that are covered by ob‐
jects.
▷ If the vehicle is too close to the vehicle ahead.
▷ Up to 10 seconds after switching on drive-
ready state using the Start/Stop button.
A Check Control message is displayed in the
event of restricted functionality.
Rear Collision Prevention
Principle
Depending on the equipment and the national-
market version, the Rear Collision Prevention can
respond to vehicles approaching from behind.
Seite 211
Safety
CONTROLS
211
Online Edition for Part no. 01405A38CB9 - VI/21
To Next Page
Loading...
Need help?
General
