Deleting a button assignment
The button assignment cannot be deleted indi‐
vidually.
Press and hold the two outer buttons on the in‐
terior mirror simultaneously for approximately
10 seconds until the LED flashes green rapidly.
All stored button assignments will be deleted.
Sun visor
Glare protection
Fold the sun visor downwards or upwards.
Protection from glare at the side
Folding the sun visor out
1.
Fold down the sun visor.
2. Unhook the sun visor from its holder and
pivot it sideways to the side window.
3. Slide it back to the desired position.
Folding the sun visor in
To close the sun visor, proceed in reverse order.
Vanity mirror
A vanity mirror is located behind a cover in the
sun visor.
Sockets
Principle
The socket can be used for electronic devices
when the standby or drive-ready state is
switched on.
General
The total load of all sockets must not exceed
140 watts at 12 V.
Do not damage the socket by using unsuitable
connectors.
Safety notes
WARNING
Devices and cables, for example portable navi‐
gation devices, that are located in the deploy‐
ment range of the airbags may impede airbag
deployment or be thrown around the vehicle in‐
terior when the airbag is deployed. There is a
danger of injury. Make sure that devices and
cables are not in the deployment range of the
airbags.
NOTE
Battery chargers that charge the vehicle battery
via sockets or cigarette lighters in the vehicle
may overload or damage the 12 V electrical
system. There is a risk of material damage. In
the case of a discharged vehicle battery, con‐
tact a manufacturer Service Partner or other
qualified Service Partner or specialist work‐
shop.
NOTE
If metallic objects fall into the socket, they can
cause a short circuit. There is a risk of material
damage. After using the socket, re-fit the
lighter or socket cover.
Seite 294
CONTROLS
Interior equipment
294
Online Edition for Part no. 01405A38CB9 - VI/21
To Next Page
Loading...
