BMW iX - Adjusting the Footwell Temperature; Air Recirculation Function; Maximum Cooling

▷ Increase the temperature.
▷ Reduce the temperature.
Setting the automatic rear air-
conditioning system temperature
Using the button:
Press the upper or lower side of the but‐
ton to set the desired temperature.
Via iDrive:
1. "CLIMATE MENU"
2. "Settings"
3. "Rear climate control"
4. Set the desired temperature.
Adjusting the footwell temperature
General
The temperature of the footwell can be adjusted.
The set interior temperature for driver and front
passenger is not changed by this.
Adjusting the footwell temperature
1.
"CLIMATE MENU"
2. "Settings"
3. "Driver" or "Passenger"
4. "Temperature adjustment for footwell"
5. Set the desired temperature.
Maximum cooling
Principle
The function enables quick and intense cooling
of the interior.
General
The system is set to the lowest temperature,
maximum amount of air and air recirculation
function.
Automatic rear air-conditioning system:
The function is automatically activated in the rear
when the SYNC programme is turned on.
When the SYNC programme is turned off, the
function is turned off in the rear to reach maxi‐
mum output in front.
Operating requirements
The function is available at an outside tempera‐
ture above approximately 0 ℃/32 ℉ and when
driving readiness or standby state is switched on.
Turning maximum cooling on/off
1.
"CLIMATE MENU"
2. "MAX A/C"
3. Select the desired setting.
Automatic rear air-conditioning system:
Press the button.
The LED in the button is illuminated
when maximum cooling is switched on.
The air flows from the air vents for the upper
body area. Open the vents.
Air recirculation function
Principle
If the air outside the vehicle has an unpleasant
odour or contains pollutants, the supply of out‐
side air into the interior of the vehicle can be shut
off. The interior air is then recirculated.
When the air recirculation function is turned off,
outside air is directed into the interior.
In the automatic recirculated-air control, outside
air is drawn in or the interior air is circulated, de‐
pending on the outside air quality. The interior fil‐
ter is active.
General
If there is condensation, switch off air recircula‐
tion function or remove the condensation.
Seite 286
CONTROLS
Air conditioning
286
Online Edition for Part no. 01405A38CB9 - VI/21