Towing eye
General
Always keep the screw-on towing eye in the ve‐
hicle.
The towing eye can be screwed in at the front or
rear of the vehicle.
The towing eye is located in the toolkit.
Observe the following notes when using the tow‐
ing eye:
▷ Only use the towing eye supplied with the ve‐
hicle.
▷ Turn the towing eye at least 5 turns clock‐
wise and screw it in tight and as far as it will
go. If necessary, tighten with a suitable ob‐
ject.
▷ After use, unscrew the towing eye in an anti-
clockwise direction.
▷ Only use the towing eye for towing on paved
roads.
▷ Avoid transverse loads on the towing eye, for
example do not raise the vehicle by the tow‐
ing eye.
▷ Check the towing eye fastening regularly.
For further information:
Toolkit, see page 362.
Safety note
NOTE
If the towing eye is not used as intended, the
vehicle or towing eye may be damaged. There
is a risk of material damage. Observe the notes
on using the towing eye.
Thread for towing eye
Press the marking on the edge of the cover to
press it out.
Seite 374
MOBILITY
Help in case of a breakdown
374
Online Edition for Part no. 01405A38CB9 - VI/21
To Next Page
Loading...
Need help?
General
