EasyManua.ls Logo

BMW iX - Start-Up Monitoring; Turning Start-Up Monitoring On;Off

BMW iX
416 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System limits
If applicable, turn off the system temporarily, if
needed.
The system limits of the Park Distance Control
PDC and the Park Assist apply.
For further information:
Park Distance Control, PDC, see page 253.
Park Assist, see page 265.
Start-up monitoring
Principle
In case of a risk of collision, the start-up monitor‐
ing reduces the drive power at drive-off.
General
When obstacles are detected in close range in
front of the vehicle, the acceleration will be re‐
duced. If necessary, this permits timely manual
braking.
When obstacles are detected behind the vehicle,
the system will brake.
Safety notes
WARNING
The system does not relieve you of your per‐
sonal responsibility to assess the traffic situa‐
tion correctly. Due to system limits, it cannot
respond independently and appropriately in all
traffic situations. There is a risk of accident.
Adapt your driving style to the traffic conditions.
In addition, look directly to check the traffic sit‐
uation and the vehicle surroundings and inter‐
vene actively where appropriate.
NOTE
The system can steer the vehicle over or onto
kerbs. There is a risk of material damage. Ob‐
serve the traffic situation and intervene actively
if the situation warrants it.
Overview
Sensors
The system is controlled using the following sen‐
sors:
Ultrasonic sensors in the front/rear bumpers.
Side ultrasonic sensors.
Operating requirements
Selector lever position D, B or R is engaged
when the vehicle is stationary.
Obstacles are detected in close range in front
of or behind the vehicle.
The accelerator pedal is applied forcefully, al‐
most as far as it will go.
The accelerator pedal is applied as soon as
the selector lever position is engaged and the
obstacle is detected.
Turning start-up monitoring on/off
1.
Press the button.
2. "Driver assistance"
3. "Parking"
4. "Start monitoring"
5. "Start monitoring"
A Check Control message is shown where appli‐
cable.
Depending on the national-market version, the
system is automatically turned on again at the
next drive.
Seite 257
Parking
CONTROLS
257
Online Edition for Part no. 01405A38CB9 - VI/21

Table of Contents

Other manuals for BMW iX

Related product manuals