Adjustments and Calibrations 6-9
Adjusting Fuser Temperature
Four temperature settings, listed in the following Fuser Temperatures table, are
available for each paper type supported by the printer. The default fuser temperature
setting for each paper type is listed in the following Fuser Configuration Defaults
table.
To change the fuser setting for a particular paper type:
1. From the Main Menu, select Printer Setup, then press the OK button.
2. Select Paper Handling Setup, then press the OK button.
3. Select Fuser Configuration, then press the OK button.
4. Select Temperature for [paper type], then press the OK button
5. Select a temperature setting from the four available, then press the OK button to
place a check mark by that setting.
Note
You must scroll up to see the Extra High setting.
6. Select Exit, then press the OK button.
Fuser Temperatures
Temperature Setting Low Medium High Extra High
Temperature Range 185° C
365° F
200 - 205° C
392 - 401° F
210° C
410° F
215° C
419° F
Fuser Configuration Defaults
Paper Type Default Fuser Temperature Setting
Plain Medium
Letterhead Medium
Transparency Low
Labels High
Colored Paper Medium
Card Stock High
Envelope High
Special Medium
To Next Page
Loading...
Need help?
General