Xerox Phaser 4500 Service Manual

Adjustments and Calibrations 6-11
Resetting Printer Values to the Factory Default
Values
You can reset printer values on the following menus to the factory default settings:
■ Connection Setup
■ Paper Handling Setup
■ PostScript Setup
■ PCL Setup
■ General Setup
■ Front Panel Setup
■ Printer Controls
■ File Security (available if the printer has a hard drive)
You can reset all of the Image Processor Board NVRAM-stored parameters to their
factory default values by resetting the PostScript NVRAM. Instructions for resetting
PostScript NVRAM are in “Resetting All Printer Default Settings (PostScript
NVRAM)” on page 6-14.
Note
There is no single reset for the Print Engine NVRAM.
Resetting Connection Setup Values
Resetting the connection setup values resets the Printer Name, TCP/IP address, TCP/
IP address menu settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk,
NetWare, set IPX frame type, IPP, and Ethernet speed to their default values.
Caution
Before resetting the connection setup values to factory default values, make note
of the current network settings or print a Configuration Page to record the
printer’s current network settings.
1. From the Main Menu, select Connection Setup, then press the OK button.
2. Select Reset Connection Setup, then press the OK button.
3. Select Reset Connection Setup NOW, then press the OK button.

Xerox Phaser 4500 Specifications

General

Brand	Xerox
Model	Phaser 4500
Category	Printer
Language	English