FRU Disassembly 8-3
General Notes on Disassembly
Preparation
Before you begin any Removal and Replacement Procedure:
1. Switch OFF the printer power and disconnect the power cord from the wall
outlet.
2. Remove the Print Cartridge and protect it from exposure to light by covering it
with a light proof bag or by placing it in a light-tight container. Disconnect all
computer interface cables from the printer.
3. Wear an electrostatic discharge wrist strap to help prevent damage to the sensitive
electronics of the printer circuit boards.
4. Remove the Fuser Assembly or wait at least 5 minutes after you have switched
OFF printer power for the Fuser to cool before you work on or around the Fuser.
Caution
Many parts are secured by plastic tabs. DO NOT over Flex or force these parts.
Do not over torque the screws threaded into plastic parts.
Note
Names of parts that appear in the disassembly procedures may not be exactly the
same as the names that appear in the Parts List. For example; a part called the
Registration Chute Assembly may appear on the Parts List as Assembly, Chute
REGI.
Caution
Always use the correct type and size screw. Using the wrong screw can damage
tapped holes. Do not use excessive force to either remove or install either a screw
or a printer part.
Warning
Unplug the AC power cord from the wall outlet before removing any printer part.
Notations in the Disassembly Text
■ The notation “PLX.X.X” indicates that this component is listed in the FRU Parts
List.
■ Bold arrows in an illustration show direction of movement when removing or
replacing a component.
To Next Page
Loading...
Need help?
General