To Next Page

To Previous Page

B-8

Catalyst 3750-X and 3560-X Switch Command Reference

OL-29704-01

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug cluster

Use the debug cluster privileged EXEC command to enable debugging of cluster-specific events. Use

the no form of this command to disable debugging.

debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat | neighbors

| platform | snmp | vqpxy}

no debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat |

neighbors | platform | snmp | vqpxy}

Syntax Description

Defaults Debugging is disabled.

Command Modes Privileged EXEC

Command History

Usage Guidelines This command is available only on the cluster command switch stack or cluster command switch.

The undebug cluster command is the same as the no debug cluster command.

When you enable debugging on a switch stack, it is enabled only on the stack master. To enable

debugging on a stack member, you can start a session from the stack master by using the session

switch-number privileged EXEC command. Then enter the debug command at the command-line

prompt of the stack member. You also can use the remote command stack-member-number LINE

privileged EXEC command on the stack master switch to enable debugging on a member switch without

first starting a session.

discovery Display cluster discovery debug messages.

events Display cluster event debug messages.

extended Display extended discovery debug messages.

hsrp Display the Hot Standby Router Protocol (HSRP) debug messages.

http Display Hypertext Transfer Protocol (HTTP) debug messages.

ip [packet] Display IP or transport packet debug messages.

members Display cluster member debug messages.

nat Display Network Address Translation (NAT) debug messages.

neighbors Display cluster neighbor debug messages.

platform Display platform-specific cluster debug messages.

snmp Display Simple Network Management Protocol (SNMP) debug messages.

vqpxy Display VLAN Query Protocol (VQP) proxy debug messages.

Release Modification

12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Command Reference

Other manuals for Cisco Catalyst 3750-X