B-37
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug pagp
debug pagp
Use the debug pagp privileged EXEC command to enable debugging of Port Aggregation Protocol
(PAgP) activity. Use the no form of this command to disable debugging.
debug pagp [all | dual-active | event | fsm | misc | packet]
no debug pagp [all | dual-active | event | fsm | misc | packet]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug pagp command is the same as the no debug pagp command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all (Optional) Display all PAgP debug messages.
dual-active (Optional) Display dual-active detection messages.
event (Optional) Display PAgP event debug messages.
fsm (Optional) Display PAgP finite state-machine debug messages.
misc (Optional) Display miscellaneous PAgP debug messages.
packet (Optional) Display PAgP packet debug messages.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show pagp Displays PAgP channel-group information.
To Next Page
Loading...
Need help?
General