To Next Page

To Previous Page

B-48

Catalyst 3750-X and 3560-X Switch Command Reference

OL-29704-01

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform etherchannel

Use the debug platform etherchannel privileged EXEC command to enable debugging of

platform-dependent EtherChannel events. Use the no form of this command to disable debugging.

debug platform etherchannel {init | link-up | rpc | warnings}

no debug platform etherchannel {init | link-up | rpc | warnings}

Syntax Description

Defaults Debugging is disabled.

Command Modes Privileged EXEC

Command History

Usage Guidelines The undebug platform etherchannel command is the same as the no debug platform etherchannel

command.

When you enable debugging on a switch stack, it is enabled only on the stack master. To enable

debugging on a stack member, you can start a session from the stack master by using the session

switch-number privileged EXEC command. Then enter the debug command at the command-line

prompt of the stack member. You also can use the remote command stack-member-number LINE

privileged EXEC command on the stack master switch to enable debugging on a member switch without

first starting a session.

Related Commands

init Display EtherChannel module initialization debug messages.

link-up Display EtherChannel link-up and link-down related debug messages.

rpc Display EtherChannel remote procedure call (RPC) debug messages.

warnings Display EtherChannel warning debug messages.

Release Modification

12.2(53)SE2 This command was introduced.

Command Description

show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3750-X Command Reference

Other manuals for Cisco Catalyst 3750-X