EasyManuals Logo
Home>Cisco>Switch>Catalyst 3750-X

Cisco Catalyst 3750-X Command Reference

Cisco Catalyst 3750-X
1244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #316 background imageLoading...
Page #316 background image
2-284
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
ip igmp profile
ip igmp profile
Use the ip igmp profile global configuration command on the switch stack or on a standalone switch to
create an Internet Group Management Protocol (IGMP) profile and enter IGMP profile configuration
mode. From this mode, you can specify the configuration of the IGMP profile to be used for filtering
IGMP membership reports from a switchport. Use the no form of this command to delete the IGMP
profile.
ip igmp profile profile number
no ip igmp profile profile number
Syntax Description
Defaults No IGMP profiles are defined. When configured, the default action for matching an IGMP profile is to
deny matching addresses.
Command Modes Global configuration
Command History
Usage Guidelines When you are in IGMP profile configuration mode, you can create the profile by using these commands:
• deny: specifies that matching addresses are denied; this is the default condition.
• exit: exits from igmp-profile configuration mode.
• no: negates a command or resets to its defaults.
• permit: specifies that matching addresses are permitted.
• range: specifies a range of IP addresses for the profile. This can be a single IP address or a range
with a start and an end address.
When entering a range, enter the low IP multicast address, a space, and the high IP multicast address.
You can apply an IGMP profile to one or more Layer 2 interfaces, but each interface can have only one
profile applied to it.
Examples This example shows how to configure IGMP profile 40 that permits the specified range of IP multicast
addresses:
Switch(config)# ip igmp profile 40
Switch(config-igmp-profile)# permit
Switch(config-igmp-profile)# range 233.1.1.1 233.255.255.255
You can verify your settings by using the show ip igmp profile privileged EXEC command.
profile number The IGMP profile number being configured. The range is 1 to 4294967295.
Release Modification
12.2(53)SE2 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3750-X
CategorySwitch
LanguageEnglish

Related product manuals