To Next Page

To Previous Page

B-53

Catalyst 3750-X and 3560-X Switch Command Reference

OL-29704-01

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform ip dhcp

Use the debug platform ip dhcp privileged EXEC command to debug DHCP events. Use the no form

of this command to disable debugging.

debug platform ip dhcp [all | error | event | packet | rpc]

no debug platform ip dhcp [all | error | event | packet | rpc]

Syntax Description

Defaults Debugging is disabled.

Command Modes Privileged EXEC

Command History

Usage Guidelines The undebug platform ip dhcp command is the same as the no debug platform ip dhcp command.

When you enable debugging on a switch stack, it is enabled only on the stack master. To enable

debugging on a stack member, you can start a session from the stack master by using the session

switch-number privileged EXEC command. Then enter the debug command at the command-line

prompt of the stack member. You also can use the remote command stack-member-number LINE

privileged EXEC command on the stack master switch to enable debugging on a member switch without

first starting a session.

Related Commands

all (Optional) Display all DHCP debug messages.

error (Optional) Display DHCP error debug messages.

event (Optional) Display DHCP event debug messages.

packet (Optional) Display DHCP packet-related debug messages.

rpc (Optional) Display DHCP remote procedure call (RPC) request debug

messages.

Release Modification

12.2(53)SE2 This command was introduced.

Command Description

show ip dhcp snooping Displays the DHCP snooping configuration.

show ip dhcp snooping

binding

Displays the DHCP snooping binding information.

show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3750-X Command Reference

Other manuals for Cisco Catalyst 3750-X