Cisco Catalyst 3750-X Command Reference

2-448
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
nmsp
nmsp
Use the nmsp global configuration command to enable Network Mobility Services Protocol (NMSP) on
the switch. Use the no form of this command to return to the default setting.
nmsp {enable | {notification interval {attachment | location} interval-seconds}}
no nmsp {enable | {notification interval {attachment | location} interval-seconds}}
Syntax Description
Defaults NMSP is disabled.
Command Modes Global configuration
Command History
Usage Guidelines Use the nmsp global configuration command to enable the switch to send NMSP location and
attachment notifications to a Cisco Mobility Services Engine (MSE).
Examples This example shows how to enable NMSP on a switch and set the location notification time to 10
seconds:
Switch(config)# nmsp enable
Switch(config)# nmsp notification interval location 10
Related Commands
enable Enable the NMSP features on the switch.
notification interval Specify the NMSP notification interval.
attachment Specify the attachment notification interval.
location Specify the location notification interval.
interval-seconds Duration in seconds before a switch sends the MSE the location or
attachment updates. The range is 1 to 30; the default is 30.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
clear nmsp statistics Clears the NMSP statistic counters.
nmsp attachment suppress Suppresses reporting attachment information from a specified
interface.
show nmsp Displays the NMSP information.

Cisco Catalyst 3750-X Specifications

General

Brand	Cisco
Model	Catalyst 3750-X
Category	Switch
Language	English