To Next Page

To Previous Page

B-61

Catalyst 3750-X and 3560-X Switch Command Reference

OL-29704-01

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform ipc

Use the debug platform ipc privileged EXEC command to enable debugging of the platform-dependent

Interprocess Communication (IPC) Protocol. Use the no form of this command to disable debugging.

debug platform ipc {all | init | receive | send | trace}

no debug platform {all | init | receive | send | trace}

Note This command is supported only on Catalyst 3750-X switches.

Syntax Description

Defaults Debugging is disabled.

Command Modes Privileged EXEC

Command History

Usage Guidelines The undebug platform ipc command is the same as the no debug platform ipc.

When you enable debugging on a switch stack, it is enabled only on the stack master. To enable

debugging on a stack member, you can start a session from the stack master by using the session

switch-number privileged EXEC command. Then enter the debug command at the command-line

prompt of the stack member. You also can use the remote command stack-member-number LINE

privileged EXEC command on the stack master switch to enable debugging on a member switch without

first starting a session.

Related Commands

all Display all platform IPC debug messages.

Note Using this command can degrade the performance of the switch.

init Display debug messages related to IPC initialization.

receive Display IPC traces each time an IPC packet is received by the switch.

send Display IPC traces each time an IPC packet is sent by the switch.

trace Display IPC trace debug messages, tracing the code path as the IPC functions are

executed.

Release Modification

12.2(53)SE2 This command was introduced.

Command Description

show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3750-X Command Reference

Other manuals for Cisco Catalyst 3750-X