2-124
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
cluster commander-address
cluster commander-address
You do not need to enter this command from the switch stack or from a standalone cluster member switch.
The cluster command switch automatically provides its MAC address to cluster member switches when
these switches join the cluster. The cluster member switch adds this information and other cluster
information to its running configuration file. Use the no form of this global configuration command from
the cluster member switch console port or Ethernet management port to remove the switch from a cluster
only during debugging or recovery procedures.
cluster commander-address mac-address [member number name name]
no cluster commander-address
Syntax Description
Defaults The switch is not a member of any cluster.
Command Modes Global configuration
Command History
Usage Guidelines This command is available only on the cluster command switch stack or the cluster command switch.
A cluster member can have only one cluster command switch.
The cluster member switch retains the identity of the cluster command switch during a system reload by
using the mac-address parameter.
You can enter the no form on a cluster member switch to remove it from the cluster during debugging or
recovery procedures. You would normally use this command from the cluster member switch console
port or Ethernet management port only when the member has lost communication with the cluster
command switch. With normal switch configuration, we recommend that you remove cluster member
switches only by entering the no cluster member n global configuration command on the cluster
command switch.
When a standby cluster command switch becomes active (becomes the cluster command switch), it
removes the cluster commander address line from its configuration.
mac-address MAC address of the cluster command switch.
member number (Optional) Number of a configured cluster member switch. The range is 0
to 15.
name name (Optional) Name of the configured cluster up to 31 characters.
Release Modification
12.2(53)SE2 This command was introduced.
To Next Page
Loading...
Need help?
General