2-641
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show flowcontrol
show flowcontrol
Use the show flowcontrol user EXEC command to display the flow control status and statistics.
show flowcontrol [interface interface-id | module number]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Use this command to display the flow control status and statistics on the switch or for a specific interface.
Use the show flowcontrol command to display information about all the switch interfaces. For a
standalone switch, the output from the show flowcontrol command is the same as the output from the
show flowcontrol module number command.
Use the show flowcontrol interface interface-id command to display information about a specific
interface.
Examples This is an example of output from the show flowcontrol command.
Switch> show flowcontrol
Port Send FlowControl Receive FlowControl RxPause TxPause
admin oper admin oper
--------- -------- -------- -------- -------- ------- -------
Gi2/0/1 Unsupp. Unsupp. off off 0 0
Gi2/0/2 desired off off off 0 0
Gi2/0/3 desired off off off 0 0
<output truncated>
This is an example of output from the show flowcontrol interface interface-id command:
Switch> show flowcontrol gigabitethernet2/0/2
Port Send FlowControl Receive FlowControl RxPause TxPause
admin oper admin oper
--------- -------- -------- -------- -------- ------- -------
Gi2/0/2 desired off off off 0 0
interface interface-id (Optional) Display the flow control status and statistics for a specific
interface.
module number (Optional) Display the flow control status and statistics for all interfaces on the
switch or specified stack member.
On Catalyst 3750-X switches, the range is 1 to 9.
On Catalyst 3560-X switches, the only valid module number is 1.
This option is not available if you have entered a specific interface ID.
Release Modification
12.2(53)SE2 This command was introduced.
To Next Page
Loading...
Need help?
General