2-354
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
location (global configuration)
location (global configuration)
Use the location global configuration command to configure location information for an endpoint. Use
the no form of this command to remove the location information.
location {admin-tag string | civic-location identifier id | elin-location string identifier id}
no location {admin-tag string | civic-location identifier id | elin-location string identifier id}
Syntax Description
Defaults This command has no default setting.
Command Modes Global configuration
Command History
Usage Guidelines After entering the location civic-location identifier id global configuration command, you enter civic
location configuration mode. In this mode, you can enter the civic location and the postal location
information.
The civic-location identifier must not exceed 250 bytes.
Use the no lldp med-tlv-select location information interface configuration command to disable the
location TLV. The location TLV is enabled by default. For more information, see the “Configuring LLDP
and LLDP-MED” chapter of the software configuration guide for this release.
admin-tag Configure administrative tag or site information.
civic-location Configure civic location information.
elin-location Configure emergency location information (ELIN).
identifier id Specify the ID for the civic location or the elin location. The ID range
is 1 to 4095.
Note The identifier for the civic location in the LLDP-MED TLV is
limited to 250 bytes or less. To avoid error messages about
available buffer space during switch configuration, be sure that
the total length of all civic-location information specified for
each civic-location identifier does not exceed 250 bytes.
string Specify the site or location information in alphanumeric format.
Release Modification
12.2(53)SE2 This command was introduced.
To Next Page
Loading...
Need help?
General