2-918
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
switch renumber
switch renumber
Use the switch renumber global configuration command on the stack master to change the stack
member number.
switch current-stack-member-number renumber new-stack-member-number
Note This command is supported only on Catalyst 3750-X switches.
Syntax Description
Defaults The default stack member number is 1.
Command Modes Global configuration
Command History
Usage Guidelines If another stack member is already using the member number that you just specified, the stack master
assigns the lowest available number when you reload the stack member.
Note If you change the number of a stack member, and no configuration is associated with the new stack
member number, that stack member loses its current configuration and resets to its default configuration.
For more information about stack member numbers and configurations, see the software configuration
guide.
Do not use the switch current-stack-member-number renumber new-stack-member-number command
on a provisioned switch. If you do, the command is rejected.
Use the reload slot current stack member number privileged EXEC to reload the stack member and to
apply this configuration change.
Examples This example shows how to change the member number of stack member 6 to 7:
Switch(config)# switch 6 renumber 7
WARNING:Changing the switch number may result in a configuration change for that switch.
The interface configuration associated with the old switch number will remain as a
provisioned configuration.
Do you want to continue?[confirm]
current-stack-member-number Specify the current stack member number. The range is 1 to 9.
renumber
new-stack-member-number
Specify the new stack member number for the stack member. The
range is 1 to 9.
Release Modification
12.2(53)SE2 This command was introduced.
To Next Page
Loading...
Need help?
General