Name: Cisco Catalyst 3750-X
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

2-706

Catalyst 3750-X and 3560-X Switch Command Reference

OL-29704-01

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

show l2protocol-tunnel

Use the show l2protocol-tunnel user EXEC command to display information about Layer 2 protocol

tunnel ports. Displays information for interfaces with protocol tunneling enabled.

show l2protocol-tunnel [interface interface-id] [summary]

Note This command is not supported on switches running the LAN base feature set.

Syntax Description

Command Modes User EXEC

Command History

Usage Guidelines After enabling Layer 2 protocol tunneling on an access or IEEE 802.1Q tunnel port by using the

l2protocol-tunnel interface configuration command, you can configure some or all of these parameters:

• Protocol type to be tunneled

• Shutdown threshold

• Drop threshold

If you enter the show l2protocol-tunnel [interface interface-id] command, only information about the

active ports on which all the parameters are configured appears.

If you enter the show l2protocol-tunnel summary command, only information about the active ports

on which some or all of the parameters are configured appears.

Examples This is an example of output from the show l2protocol-tunnel command:

Switch> show l2protocol-tunnel

COS for Encapsulated Packets: 5

Drop Threshold for Encapsulated Packets: 0

Port Protocol Shutdown Drop Encapsulation Decapsulation Drop

Threshold Threshold Counter Counter Counter

---------- -------- --------- --------- ------------- ------------- -------------

Gi3/0/3 --- ---- ---- ---- ---- ----

--- ---- ---- ---- ---- ----

pagp ---- ---- 0 242500

lacp ---- ---- 24268 242640

interface interface-id (Optional) Specify the interface for which protocol tunneling information

appears. Valid interfaces are physical ports and port channels; the port

channel range is 1 to 48.

summary (Optional) Display only Layer 2 protocol summary information.

Release Modification

12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Command Reference

Other manuals for Cisco Catalyst 3750-X