To Next Page

To Previous Page

B-50

Catalyst 3750-X and 3560-X Switch Command Reference

OL-29704-01

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform forw-tcam

Use the debug platform forw-tcam privileged EXEC command to enable debugging of the forwarding

hardware memory manager. Use the no form of this command to disable debugging.

Note This command is not supported on switches running the LAN base feature set.

Syntax Description

Defaults Debugging is disabled.

Command Modes Privileged EXEC

Command History

Usage Guidelines If you do not specify a keyword, all forwarding hardware manager debug messages appear.

The undebug platform forw-tcam command is the same as the no debug platform forw-tcam

command.

When you enable debugging on a switch stack, it is enabled only on the stack master. To enable

debugging on a stack member, you can start a session from the stack master by using the session

switch-number privileged EXEC command. Then enter the debug command at the command-line

prompt of the stack member. You also can use the remote command stack-member-number LINE

privileged EXEC command on the stack master switch to enable debugging on a member switch without

first starting a session.

Related Commands

adjustment (Optional) Display hardware manager adjustment debug messages.

allocate (Optional) Display hardware manager allocation debug messages.

audit (Optional) Display hardware manager audit messages.

error (Optional) Display hardware manager error messages.

move (Optional) Display hardware manager move messages.

read (Optional) Display hardware manager read messages.

write (Optional) Display hardware manager write messages.

Release Modification

12.2(53)SE2 This command was introduced.

Command Description

show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3750-X Command Reference

Other manuals for Cisco Catalyst 3750-X