2-808
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show storm-control
show storm-control
Use the show storm-control user EXEC command to display broadcast, multicast, or unicast storm
control settings on the switch or on the specified interface or to display storm-control history.
show storm-control [interface-id] [broadcast | multicast | unicast]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines When you enter an interface-id, the storm control thresholds appear for the specified interface.
If you do not enter an interface-id, settings appear for one traffic type for all ports on the switch.
If you do not enter a traffic type, settings appear for broadcast storm control.
Examples This is an example of a partial output from the show storm-control command when no keywords are
entered. Because no traffic-type keyword was entered, the broadcast storm control settings appear.
Switch> show storm-control
Interface Filter State Upper Lower Current
--------- ------------- ---------- --------- ---------
Gi1/0/1 Forwarding 20 pps 10 pps 5 pps
Gi1/0/2 Forwarding 50.00% 40.00% 0.00%
<output truncated>
interface-id (Optional) Interface ID for the physical port (including type, stack member
(stacking-capable switches only), module, and port number).
broadcast (Optional) Display broadcast storm threshold setting.
multicast (Optional) Display multicast storm threshold setting.
unicast (Optional) Display unicast storm threshold setting.
Release Modification
12.2(53)SE2 This command was introduced.
To Next Page
Loading...
Need help?
General