Cisco Catalyst 3750-X Command Reference

C-43
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix C Catalyst 3750-X and 3560-X Show Platform Commands
show platform tb
show platform tb
Use the show platform tb privileged EXEC command to display platform-dependent trusted-boundary
information.
show platform tb
Syntax Description There are no arguments or keywords.
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with your technical support
representative while troubleshooting a problem. Do not use this command unless your technical support
representative asks you to do so.
Examples This is an example of output from the show platform tb command:
Switch# show platform tb
Print TB sub-block information
(Fa1/0/2) device:(Cisco phone)
/* current interfaces with TB enabled, and the trust device type */
Current master switch:(Yes)
/* Is this switch the current master switch? */
New elected master :(No)
/* Is the master switch-over occurred and this is the new master switch? */
Master ready :(No)
/* Is the Master switch in ready state? */
HULC TB process on :(No)
/* Is the TB platform process currently running? */
CDP stable timer ON :(No)(360 secs)
/* Is the CDP stable timer running? After the CDP stable timer expired, CDP neighbors of
all the TB enabled interfaces will be verified to make sure the replacement of IP phone
and PC did not happen during the master switch-over. */
Print TB residue trust ports information
/* The interfaces with TB enabled right before master switch-over. */
Print port CDP neighbor information
/* Is the CDP message still received after switch-over? */
HULC TB is not detecting CDP events
/* Currently, this switch is not detecting any CDP event. */
Release Modification
12.2(53)SE2 This command was introduced.

Cisco Catalyst 3750-X Specifications

General

Brand	Cisco
Model	Catalyst 3750-X
Category	Switch
Language	English