To Next Page

To Previous Page

B-47

Catalyst 3750-X and 3560-X Switch Command Reference

OL-29704-01

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform dot1x

Use the debug platform dot1x privileged EXEC command to enable debugging of IEEE 802.1x events.

On switch stacks, this command enables debugging of stack-related IEEE 802.1x events. Use the no

form of this command to disable debugging.

debug platform dot1x {initialization | interface-configuration | rpc}

no debug platform dot1x {initialization | interface-configuration | rpc}

Syntax Description

Defaults Debugging is disabled.

Command Modes Privileged EXEC

Command History

Usage Guidelines The undebug platform dot1x command is the same as the no debug platform dot1x command.

When you enable debugging on a switch stack, it is enabled only on the stack master. To enable

debugging on a stack member, you can start a session from the stack master by using the session

switch-number privileged EXEC command. Then enter the debug command at the command-line

prompt of the stack member. You also can use the remote command stack-member-number LINE

privileged EXEC command on the stack master switch to enable debugging on a member switch without

first starting a session.

Related Commands

initialization Display IEEE 802.1x-authentication initialization sequence debug

messages.

interface-configuration Display IEEE 802.1x interface configuration-related debug messages.

rpc Display IEEE 802.1x remote procedure call (RPC) request debug

messages.

Release Modification

12.2(53)SE2 This command was introduced.

Command Description

show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3750-X Command Reference

Other manuals for Cisco Catalyst 3750-X