Cisco Catalyst 3750-X Command Reference

2-205
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
dot1x test timeout
dot1x test timeout
Use the dot1x test timeout global configuration command on the switch stack or on a standalone switch
to configure the timeout used to wait for EAPOL response from a port being queried for IEEE 802.1x
readiness.
dot1x test timeout timeout
Syntax Description
Defaults The default setting is 10 seconds.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to configure the timeout used to wait for EAPOL response.
There is not a no form of this command.
Examples This example shows how to configure the switch to wait 27 seconds for an EAPOL response:
Switch# dot1x test timeout 27
You can verify the timeout configuration status by entering the show run privileged EXEC command.
Related Commands
timeout Time in seconds to wait for an EAPOL response. The range is from
1 to 65535 seconds.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
dot1x test eapol-capable [interface
interface-id]
Checks for IEEE 802.1x readiness on devices connected to
all or to specified IEEE 802.1x-capable ports.

Cisco Catalyst 3750-X Specifications

General

Brand	Cisco
Model	Catalyst 3750-X
Category	Switch
Language	English