B-46
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform device-manager
debug platform device-manager
Use the debug platform device-manager privileged EXEC command to enable debugging of the
platform-dependent device manager. Use the no form of this command to disable debugging.
debug platform device-manager {all | device-info | poll | port-download | trace}
no debug platform device-manager {all | device-info | poll | port-download | trace}
Note This command is not supported on switches running the LAN base feature set.
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform device-manager command is the same as the no debug platform
device-manager command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all Display all platform device manager debug messages.
device-info Display platform device manager device structure debug messages.
poll Display platform device manager 1-second poll debug messages.
port-download Display platform device manager remote procedure call (RPC) usage debug
messages.
trace Trace platform device manager function entry and exit debug messages.
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
To Next Page
Loading...
Need help?
General