EasyManuals Logo
Home>Cisco>Switch>Catalyst 3750-X

Cisco Catalyst 3750-X Command Reference

Cisco Catalyst 3750-X
1244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #290 background imageLoading...
Page #290 background image
2-258
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
ip arp inspection vlan logging
ip arp inspection vlan logging
Use the ip arp inspection vlan logging global configuration command on the switch stack or on a
standalone switch to control the type of packets that are logged per VLAN. Use the no form of this
command to disable this logging control.
ip arp inspection vlan vlan-range logging {acl-match {matchlog | none} | dhcp-bindings {all |
none | permit} | arp-probe}
no ip arp inspection vlan vlan-range logging {acl-match | dhcp-bindings | arp-probe}
This command is available only if your switch is running the IP services feature set.
Syntax Description
Defaults All denied or all dropped packets are logged. ARP probe packets are not logged.
Command Modes Global configuration
Command History
vlan-range Specify the VLANs configured for logging.
You can specify a single VLAN identified by VLAN ID number, a range of
VLANs separated by a hyphen, or a series of VLANs separated by a comma.
The range is 1 to 4094.
acl-match {matchlog |
none}
Specify that the logging of packets is based on access control list (ACL)
matches.
The keywords have these meanings:
• matchlog—Log packets based on the logging configuration specified in
the access control entries (ACE). If you specify the matchlog keyword in
this command and the log keyword in the permit or deny ARP access-list
configuration command, Address Resolution Protocol (ARP) packets
permitted or denied by the ACL are logged.
• none—Do not log packets that match ACLs.
dhcp-bindings
{permit | all | none}
Specify the logging of packets is based on Dynamic Host Configuration
Protocol (DHCP) binding matches.
The keywords have these meanings:
• all—Log all packets that match DHCP bindings.
• none—Do not log packets that match DHCP bindings.
• permit—Log DHCP-binding permitted packets.
arp-probe Specify logging of packets permitted specifically because they are ARP
probes.
Release Modification
12.2(53)SE2 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3750-X
CategorySwitch
LanguageEnglish

Related product manuals