2-581
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show cluster
show cluster
Use the show cluster user EXEC command to display the cluster status and a summary of the cluster to
which the switch belongs. This command can be entered on the cluster command switch and cluster
member switches.
show cluster
Syntax Description This command has no arguments or keywords.
Command Modes User EXEC
Command History
Usage Guidelines If you enter this command on a switch that is not a cluster member, the error message
Not a management
cluster member
appears.
On a cluster member switch, this command displays the identity of the cluster command switch, the
switch member number, and the state of its connectivity with the cluster command switch.
On a cluster command switch stack or cluster command switch, this command displays the cluster name
and the total number of members. It also shows the cluster status and time since the status changed. If
redundancy is enabled, it displays the primary and secondary command-switch information.
Examples This is an example of output when the show cluster command is entered on the active cluster command
switch:
Switch> show cluster
Command switch for cluster “Ajang”
Total number of members: 7
Status: 1 members are unreachable
Time since last status change: 0 days, 0 hours, 2 minutes
Redundancy: Enabled
Standby command switch: Member 1
Standby Group: Ajang_standby
Standby Group Number: 110
Heartbeat interval: 8
Heartbeat hold-time: 80
Extended discovery hop count: 3
This is an example of output when the show cluster command is entered on a cluster member switch:
Switch1> show cluster
Member switch for cluster “hapuna”
Member number: 3
Management IP address: 192.192.192.192
Command switch mac address: 0000.0c07.ac14
Heartbeat interval: 8
Heartbeat hold-time: 80
Release Modification
12.2(53)SE2 This command was introduced.
To Next Page
Loading...
Need help?
General