EasyManuals Logo
Home>Cisco>Switch>Catalyst 3750-X

Cisco Catalyst 3750-X Command Reference

Cisco Catalyst 3750-X
1244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #634 background imageLoading...
Page #634 background image
2-602
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show controllers power inline
show controllers power inline
Use the show controllers power inline user EXEC command to display the values in the registers of the
specified Power over Ethernet (PoE) controller.
show controllers power inline [instance] [module switch-number]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Though visible on all switches, this command is valid only for PoE switches. It provides no information
for switches that do not support PoE.
The output provides information that might be useful for Cisco technical support representatives
troubleshooting the switch.
Examples This is an example of output from the show controllers power inline command:
Switch> show controllers power inline
Alchemy instance 0, address 0
Pending event flag : N N N N N N N N N N N N N N N N
Current State : 11 55 55 55 55 55 55 55
Current Event : 00 11 11 11 11 11 11 11
Timers : 1A 1A 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Error State : 00 00 00 00 00 00 00 00
Error Code : 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Power Status : N N Y Y Y Y Y Y Y Y Y Y Y Y Y Y
Auto Config : Y Y Y Y Y Y Y Y Y Y Y Y Y Y Y Y
Disconnect : N N N N N N N N N N N N N N N N
Detection Status : 55 55 55 55 55 55 55 55
Current Class : 00 44 44 44 44 44 44 44
Tweetie debug : 00 00 00 00
POE Commands pending at sub:
Command 0 on each port : 00 00 00 00 00 00 00 00
Command 1 on each port : 00 00 00 00 00 00 00 00
Command 2 on each port : 00 00 00 00 00 00 00 00
Command 3 on each port : 00 00 00 00 00 00 00 00
Alchemy instance 1, address 7
instance (Optional) Power controller instance, where each instance corresponds to four
ports. The possible range is 0 to 11, depending on the number of ports.
module switch
number
(Optional) Limit the display to ports on the specified stack member. The switch
number is 1 to 9.
This keyword is available only on stacking-capable switches.
Release Modification
12.2(53)SE2 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3750-X
CategorySwitch
LanguageEnglish

Related product manuals