Cisco Catalyst 3750-X Command Reference

B-30
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
debug matm move update
debug matm move update
Use the debug matm move update privileged EXEC command to enable debugging of MAC
address-table move update message processing.
debug matm move update
no debug matm move update
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug matm move update command is the same as the no debug matm move update command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
Release Modification
12.2(53)SE2 This command was introduced.
Command Description
mac address-table
move update {receive |
transmit}
Configures MAC address-table move update feature on the switch.
show debugging Displays information about the types of debugging that are enabled.
show mac
address-table move
update
Displays the MAC address-table move update information on the switch.

Cisco Catalyst 3750-X Specifications

General

Brand	Cisco
Model	Catalyst 3750-X
Category	Switch
Language	English