2-500
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
power xps port
power xps port
To configure and manage a Cisco eXpandable Power System (XPS) 2200 port connected to a Catalyst
3750-X or Catalyst 3650-X switch, use the power xps port command in privileged EXEC mode.
power xps switch-number port {port-number | connected} mode {enable | disable} | priority
value | role {auto | rps}
Syntax Description
Defaults The port mode is enabled.
The port priority in RPS mode is the same as the port number.
The port role is auto, determined by the connected switch.
Command Modes Privileged EXEC
Command History
switch-number Specifies the stack member to which the XPS 2200 is connected. The
range is 1 to 9, depending on the switch member numbers in the stack.
This variable appears only on Catalyst 3750-X switches.
port-number | connected Specifies the port to configure.
• port-number—Identify the XPS port number. The range is from 1
to 9.
• connected—If you do not know the XPS port number, enter
connected to identify the port to which the switch is connected.
mode {enable | disable} Specifies the operation mode of the XPS port.
• enable—Sets the port mode to enable. This is the default.
• disable—Sets the port mode to disable.
priority value Sets the priority of the port to receive power when the port and a power
supply are in redundant power supply (RPS) mode. The range is from 1
to 9. The default priority is the port number.
role {auto | rps} Sets the mode of the XPS port.
• auto—The mode is determined by the switch connected to the port.
When a Catalyst 3750-X switch running the IP base or IP services
image is connected, the role is stack power (SP). When a Catalyst
3560-X switch or a Catalyst 3750-X switch running the LAN base
image is connected, the mode is RPS. This is the default.
• rps—Sets the port mode to RPS regardless of the connected switch.
Release Modification
12.2(55)SE1 This command was introduced.