EasyManuals Logo

KTM 300 EXC TPI 2019 Repair Manual

KTM 300 EXC TPI 2019
387 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #165 background imageLoading...
Page #165 background image
WIRING HARNESS, BATTERY 15
163
Contact disks
A
must be mounted under the screw
5
and
the cable lug
6
with the claws toward the battery terminal.
Finishing work
Mount the seat. ( p. 121)
15.8 Recharging the battery
Warning
Risk of injuryBatteries contain harmful substances.
Keep batteries out of the reach of children.
Keep sparks and open flames away from the batteries.
Only charge batteries in well-ventilated rooms.
Maintain a minimum clearance from inflammable materials when charging batteries.
Minimum clearance 1 m (3 ft)
Do not charge deeply discharged batteries if charge is already below the minimum voltage.
Minimum voltage before the start of the charge 9 V
Dispose of batteries with less than the minimum voltage correctly.
Note
Environmental hazardBatteries contain environmentally-hazardous materials.
Do not dispose of batteries as household waste.
Dispose of batteries at a collection point for used batteries.
Note
Environmental hazardHazardous substances cause environmental damage.
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Even when there is no load on the battery, it discharges steadily.
The charging level and the method of charging are very important for the service life of the battery.
Rapid recharging with a high charging current shortens the service life of the battery.
If the charging current, charging voltage, or charging time are exceeded, the battery will be destroyed.
If the battery is depleted by repeated starting, the battery must be charged immediately.
If the battery is left in a discharged state for an extended period, it will become over-discharged and sul-
fated, destroying the battery.
The battery is maintenance-free.
Preparatory work
(All EXC models)
Press and hold the kill switch while the engine is idling
until the engine stops.
(All XCW models)
Press and hold the kill switch while the engine is idling
until the engine stops.
Remove the seat. ( p. 121)
Disconnect the negative cable of the battery. ( p. 160)

Table of Contents

Other manuals for KTM 300 EXC TPI 2019

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KTM 300 EXC TPI 2019 and is the answer not in the manual?

KTM 300 EXC TPI 2019 Specifications

General IconGeneral
Displacement293.2 cm³
Bore x Stroke72 mm x 72 mm
StarterElectric starter
Transmission6-speed
CoolingLiquid cooled
Rear SuspensionWP XPLOR PDS shock absorber
Seat Height960 mm
Ground Clearance370 mm
Fuel Tank Capacity9.5 liters
Engine Type2-stroke
Fuel SystemTransfer Port Injection (TPI)
FrameCentral double-cradle type 25CrMo4 steel
Front SuspensionWP Xplor 48
Front BrakeDisc brake
Rear BrakeDisc brake 220 mm

Related product manuals