FORK, TRIPLE CLAMP 6
65
R02805-10
–
Press the new bearing ring up to the stop with special tool
3
.
Tool bracket (58429089000) ( p. 368)
Pressing tool (58429091000) ( p. 368)
R01337-10
–
Remove lower steering head bearing
5
.
– Remove the seal ring.
– Grease and mount the new seal ring.
– Press on the new bearing with a suitable tube as far as it will
go.
Info
Only press the bearing in via the inner ring.
Finishing work
– Install the lower triple clamp. ( p. 62)
– Mount the handlebar cushion.
– Install front fender. ( p. 134)
– Install the front wheel. ( p. 142)
– Install the headlight mask with the headlight. ( p. 135)
– Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
–
Check the play of the steering head bearing. ( p. 65)
– Remove the motorcycle from the lift stand. ( p. 12)
– Check the headlight setting. ( p. 183)
6.11.13 Checking the play of the steering head bearing
Warning
Danger of accidents Incorrect steering head bearing play impairs the handling characteristic and dam-
ages components.
– Correct incorrect steering head bearing play immediately.
Info
If the vehicle is operated for a lengthy period with play in the steering head bearing, the bearings and the
bearing seats in the frame can become damaged over time.
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 12)
To Next Page
Loading...
Need help?
General
