EasyManuals Logo

KTM 300 EXC TPI 2019 Repair Manual

KTM 300 EXC TPI 2019
387 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #279 background imageLoading...
Page #279 background image
CLUTCH 19
277
E01224-10
Now press the fluid into the system until it emerges from the
hole
6
of the master cylinder without bubbles.
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
Remove the bleeding syringe. Tighten the bleeder screw.
Mount protection cap.
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
Position cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
19.3 Checking the clutch
Danger
Fire hazardFuel is highly flammable.
The fuel in the fuel tank expands when warm and can escape if overfilled.
Do not refuel the vehicle in the vicinity of open flames or lit cigarettes.
Switch off the engine for refueling.
Make sure that no fuel is spilled; particularly not on hot parts of the vehicle.
If any fuel is spilled, wipe it off immediately.
Observe the specifications for refueling.
Warning
Danger of poisoningFuel is poisonous and a health hazard.
Avoid skin, eye and clothing contact with fuel.
Immediately consult a doctor if you swallow fuel.
Do not inhale fuel vapors.
In case of skin contact, rinse the affected area with plenty of water.
Rinse the eyes thoroughly with water, and consult a doctor in case of fuel contact with the eyes.
Change your clothing in case of fuel spills on them.
Keep fuels correctly in a suitable canister, and out of the reach of children.
R02786-10
Main work
Drain the fuel from the fuel tank into a suitable container.
Lay the vehicle on its side on the work stand.
Info
Cover the components to protect them against damage.
Remaining fuel may flow out of the fuel tank.

Table of Contents

Other manuals for KTM 300 EXC TPI 2019

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KTM 300 EXC TPI 2019 and is the answer not in the manual?

KTM 300 EXC TPI 2019 Specifications

General IconGeneral
Displacement293.2 cm³
Bore x Stroke72 mm x 72 mm
StarterElectric starter
Transmission6-speed
CoolingLiquid cooled
Rear SuspensionWP XPLOR PDS shock absorber
Seat Height960 mm
Ground Clearance370 mm
Fuel Tank Capacity9.5 liters
Engine Type2-stroke
Fuel SystemTransfer Port Injection (TPI)
FrameCentral double-cradle type 25CrMo4 steel
Front SuspensionWP Xplor 48
Front BrakeDisc brake
Rear BrakeDisc brake 220 mm

Related product manuals