Suzuki VZR1800 2008 User Manual

3-78 ENGINE
ENGINE REASSEMBLY
• Reassemble the engine in the reverse order of disassembly.
• The following steps require special attention or precautionary
measures should be taken.
NOTE:
Apply engine oil to each running and sliding part before reas-
sembling.
CRANKSHAFT
• Install the crankshaft assembly to the upper crankcase.
• Apply a MOLYBDENUM OIL SOLUTION to each crankshaft
journal and bearing lightly.
( MOLYBDENUM OIL SOLUTION
• Insert the thrust bearing with oil groove A facing the crank
web.
BALANCER SHAFT
• Install the balancer shaft on the upper crankcase.
NOTE:
Align the C-ring with the groove of bearing and the bearing pin
with the indent on the bearing.
• Set the balancer shaft so that its punch mark A is aligned
with the punch mark B on the crankshaft.

Suzuki VZR1800 2008 Specifications

General

Displacement	1783 cc
Bore x Stroke	112.0 mm x 90.5 mm
Compression Ratio	10.5:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Transmission	5-speed constant mesh
Final Drive	Shaft drive
Front Suspension	Inverted telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Engine Type	4-stroke, liquid-cooled, DOHC, V-twin
Front Tire	130/70R18M/C 63H
Overall Length	2485mm (97.8 inches)
Overall Height	1185 mm
Ground Clearance	140 mm (5.5 in)
Seat Height	705 mm
Curb Weight	347 kg