Suzuki VZR1800 2008 User Manual

CHASSIS 9-49
INSTALLATION
Remount the swingarm and shock absorber in the reverse order
of disassembly and removal, and pay attention to the following
points.
CUSHION ROD AND CUSHION LEVER
• Install the cushion rods 1 and cushion lever 2 onto the swin-
garm temporarily.
SWINGARM
• Before installing the swingarm, install the boot and the univer-
sal joint.
NOTE:
Make sure that the “UP” mark A on the boot faces to up.
• Tighten the swingarm pivot shaft to the specified torque with
the special tool.
% 09944-28320: Hexagon socket
# Swingarm pivot shaft: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
NOTE:
After tightening the swingarm pivot shaft, be sure to check the
swingarm operation.

Suzuki VZR1800 2008 Specifications

General

Displacement	1783 cc
Bore x Stroke	112.0 mm x 90.5 mm
Compression Ratio	10.5:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Transmission	5-speed constant mesh
Final Drive	Shaft drive
Front Suspension	Inverted telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Engine Type	4-stroke, liquid-cooled, DOHC, V-twin
Front Tire	130/70R18M/C 63H
Overall Length	2485mm (97.8 inches)
Overall Height	1185 mm
Ground Clearance	140 mm (5.5 in)
Seat Height	705 mm
Curb Weight	347 kg