Suzuki VZR1800 2008 User Manual

9-72 CHASSIS
• Apply SUZUKI SILICONE GREASE to the push rod end.
. 99000-25100: SUZUKI SILICONE GREASE
or equivalent
• Install the O-ring 1 and connector 2 to the master cylinder.
MASTER CYLINDER INSTALLATION
Install the master cylinder in the reverse order of removal. Pay
attention to the following points:
• Temporarily tighten the master cylinder mounting bolts.
• Tighten the lock nut 1 and brake hose union bolt 2 to the
specified torque. (Brake hose routing:!11-40)
# Master cylinder rod lock nut 1:
18 N·m (1.8 kgf-m, 13.0 lb-ft)
Brake hose union bolt 2: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Remove the master cylinder mounting bolts.
• Apply THREAD LOCK SUPER to the master cylinder mount-
ing bolts.
* 99000-32110: THREAD LOCK SUPER “1322”
or equivalent
• Tighten the master cylinder mounting bolts to the specified
torque.
# Master cylinder mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
$
• Adjust the brake pedal height. (!2-25)
• Install the right frame head cover and right radiator cover.
(!9-7)
* The seal washers should be replaced with the new
ones to prevent brake fluid leakage.
* Bleed air from the system after reassembling the
master cylinder. (!2-26)

Suzuki VZR1800 2008 Specifications

General

Displacement	1783 cc
Bore x Stroke	112.0 mm x 90.5 mm
Compression Ratio	10.5:1
Fuel System	Fuel injection
Ignition	Electronic ignition (transistorized)
Transmission	5-speed constant mesh
Final Drive	Shaft drive
Front Suspension	Inverted telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Engine Type	4-stroke, liquid-cooled, DOHC, V-twin
Front Tire	130/70R18M/C 63H
Overall Length	2485mm (97.8 inches)
Overall Height	1185 mm
Ground Clearance	140 mm (5.5 in)
Seat Height	705 mm
Curb Weight	347 kg