January 2016
6-75
WorkCentre 4150/4250/4260WorkCentre 4150/4250/4260WorkCentre Work-
Change Tags
General Procedures and Information
Change Tags
Purpose
To provide a list of all the tag numbers used together with a description of each of the machine
modifications.
Description
Each modification to the system is assigned a unique tag number. This section of the service
documentation contains a listing and brief description of all change tags.
Tag Information
Information that may be included with each tag item is as follows:
• Tag - gives the control number for the tag.
• Class - gives the classification codes as listed in Table 1.
• Use - indicates the multinational operating markets affected by the modification.
• Manufacturing Serial Number - gives the serial number of the factory built machines with
the modification installed.
• Purpose - gives a brief description of the modification.
• Name - gives the name of the part or modification.
• Kit Number - gives the part number of the kit or part required to install the modification.
• Reference or Parts List On - indicates the parts list where the kit or modification part can
be found.
Mod / Tag Plate Location
Open the front door. The Mod / Tag plate is on the inside of the front door.
Classification Codes
The Class or Classification code can be explained as follows:
NOTE: There are currently no Tags issued for these products.
Table 1 Classification codes
NASG
code
XE
code Description
- 1 Safety: Install this tag immediately.
M 2 Mandatory: Install this tag at the next opportunity.
R 3 Repair: Install this tag as a repair, at the failure of a component.
O 4 Optional: Install as a customer option or a field engineering decision.
S 4 Situational: Install as the situation demands.
N 5 Manufacturing: Cannot be installed in the field.
- 6 Refurbishing only.
To Next Page
Loading...
Need help?
General
