Yamaha ttr230 User Manual

FRAME
6-6
FRONT WHEEL
STATIC WHEEL BALANCING
1. Remove:
• Pesos antigos para balanceamento
2. Place the wheel on an appropriate
support.
3. Find:
• Weight point (unbalance).
************************************
NOTE:
After replacing tires and rims, carry out the
static wheel balancing.
The brake disc should be installed.
Procedure:
a.Turn the wheel and wait until it stops.
b.Mark a "X1" on the lower point found.
c.Turn the wheel placing the "X1" at 90
degrees.
d.Free the wheel and wait until it stops.
Mark a "X2" on the new point found.
e.Repeat steps b, c and d until the marks
begin coincide.
f.The average point found is the weight
point.
************************************

Yamaha ttr230 Specifications

General

Engine Type	223cc air-cooled SOHC 4-stroke; 2 valves
Bore x Stroke	70.0mm x 58.0mm
Compression Ratio	9.5:1
Ignition	CDI
Transmission	Constant-mesh 6-speed; multiplate wet clutch
Final Drive	Chain
Rear Suspension	Single shock; 8.7-in travel
Front Tire	80/100-21
Rear Tire	100/100-18
Length	81.3 in
Width	31.5 in
Seat Height	34.3 in
Wheelbase	54.5 in
Ground Clearance	11.6 in
Front Suspension	Telescopic fork
Rear Brake	Drum