Yamaha ttr230 User Manual

INSP
ADJUS
FRONT BRAKE FLUID
LEVEL CHECK
3-28
FRONT BRAKE FLUID LEVEL CHECK/FRONT BRAKE PAD
CHECK
See Section “BRAKE PAD REPLACEMENT”
CHAPTER 6.
1. Actuate the brake lever
2. Check:
• Brake pads
The wear indicator is almost touching the
disc – Replace pads.
FRONT BRAKE PAD CHECK
• Use the recommended brake fluid only.
Otherwise, the rubber retainers may
deteriorate, resulting in leakage and brake
efficiency loss.
• Replenish with the same type of brake
fluid. Mixing fluids may result in chemical
reaction on the components and brake
efficiency loss.
• Make sure to prevent water from entering
the master cylinder when replenishing it.
Water decreases the fluid boiling point
and may result in accidents.
The brake fluid may damage painted or
plastic surfaces. Remove the splattered
brake fluid immediately.
2. Check:
• Brake fluid level
• Brake fluid level below the “LOWER”
mark 1 - replenish
NOTE:
• Place the motorcycle upright when
checking the brake fluid level.
• When checking the brake fluid level, make
sure the top of the master cylinder is in
the horizontal.
1. Place the motorcycle on a flat area.
CAUTION:
V
WARNING
Recommended brake fluid:
DOT # 4
Wear limit:
0.8 mm (0.76 mm)
1

Yamaha ttr230 Specifications

General

Engine Type	223cc air-cooled SOHC 4-stroke; 2 valves
Bore x Stroke	70.0mm x 58.0mm
Compression Ratio	9.5:1
Ignition	CDI
Transmission	Constant-mesh 6-speed; multiplate wet clutch
Final Drive	Chain
Rear Suspension	Single shock; 8.7-in travel
Front Tire	80/100-21
Rear Tire	100/100-18
Length	81.3 in
Width	31.5 in
Seat Height	34.3 in
Wheelbase	54.5 in
Ground Clearance	11.6 in
Front Suspension	Telescopic fork
Rear Brake	Drum