Yamaha ttr230 User Manual

INSP
ADJUS
NOTE:
If the bleeding is difficult, it may be
necessary to let the brake system stabilize
for some hours. Repeat the bleeding proce-
dure when the small bobbles have vanished
from the system.
3-30
2. Adjust:
• Brake pedal height
1. Check:
• Brake pedal height a
Out of specification => Adjust.
REAR BRAKE ADJUSTMENT
j. Replenish the brake fluid up to the level.
************************************
Adjustment steps:
• Loosen the lock-nut2.
• Turn the adjuster 1 inward or outward
until establish the specified height.
************************************
To turn inward => Increases the
pedal height.
To turn outward => Reduces the
pedal height.
REAR BRAKE ADJUSTMENT
Recommended brake fluid:
DOT #4
Check the brake system operation after the
bleeding.
V
WARNING
Brake pedal height:
3 mm (0.12 in) below the top of
the footboard.

Yamaha ttr230 Specifications

General

Engine Type	223cc air-cooled SOHC 4-stroke; 2 valves
Bore x Stroke	70.0mm x 58.0mm
Compression Ratio	9.5:1
Ignition	CDI
Transmission	Constant-mesh 6-speed; multiplate wet clutch
Final Drive	Chain
Rear Suspension	Single shock; 8.7-in travel
Front Tire	80/100-21
Rear Tire	100/100-18
Length	81.3 in
Width	31.5 in
Seat Height	34.3 in
Wheelbase	54.5 in
Ground Clearance	11.6 in
Front Suspension	Telescopic fork
Rear Brake	Drum