EasyManuals Logo

Yamaha ttr230 User Manual

Yamaha ttr230
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
INSP
ADJUS
3-18
ENGINE OIL CHANGE
5. Let the engine run for some minutes for
warming up.
Do not apply additives. The engine oil also
lubricates the clutch and additives can
cause the clutch to slip.
Prevent dust from entering the engine.
CAUTION:
ENGINE OIL CHANGE
6. Stop the engine and check the oil level
again.
Do not start the engine if the oil reservoir
is empty.
CAUTION:
Engine oil change (without filter
replacement)
1. Place the motorcycle on a flat area.
2. Warm up the engine for some minutes
and, then, stop the engine. Place a tray
under the drain plug.
Amount of oil:
Periodic change => 1.0 l
Change with filter => 1,1 l
Total capacity => 1.3 l

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha ttr230 and is the answer not in the manual?

Yamaha ttr230 Specifications

General IconGeneral
Engine Type223cc air-cooled SOHC 4-stroke; 2 valves
Bore x Stroke70.0mm x 58.0mm
Compression Ratio9.5:1
IgnitionCDI
TransmissionConstant-mesh 6-speed; multiplate wet clutch
Final DriveChain
Rear SuspensionSingle shock; 8.7-in travel
Front Tire80/100-21
Rear Tire100/100-18
Length81.3 in
Width31.5 in
Seat Height34.3 in
Wheelbase54.5 in
Ground Clearance11.6 in
Front SuspensionTelescopic fork
Rear BrakeDrum

Related product manuals