Tektronix MSO58 User Manual

Commands listed in alphabetical order
DISplay:MATH
FFTView<x>:CURSor:VBArs:UNIts? (Query Only)
This command queries the cursor A vertical units of the specified cursor in the
specified view.
Group
Cursor
Syntax
DISplay:MATHFFTView<x>:CU RSor:VBArs:UNIts?
Examples
DISplay:MATHFFTView1:CURS or:VBArs:UNIts? might return
:DISPLAY:MATHFFTVIEW1:CUR SOR:VBARS:UNITS "Hz" indicating the cursor
units are Hz.
DISplay:MATHFFTView<x>:CURSor:WAVEform:APOSition
This command sets or queries the waveform cursor A position in the specified
plot view.
NOTE. In the case of an XY plot, this command has no effect when used to set the
value. In the case of a bathtub plot, this command sets o r returns the cursor A
vertical position. For all other plots, this command sets or returns the cursor
A horizontal position.
Group
Cursor
Syntax
DISplay:MATHFFTView<x>:CU RSor:WAVEform:APOSition < NR3>
DISplay:MATHFFTView<x>:CU RSor:WAVEform:APOSition?
Arguments
<NR3> is the waveform cursor A position in the specified plot view.
Examples
DISplay:MATHFFTView1:CURS or:WAVEform:APOSition 600 .0e6 sets the
position to 600 MHz.
DISplay:MATHFFTView1:CURS or:WAVEform:APOSition? might return
:DISPLAY:MATHFFTVIEW1:CUR SOR:WAVEFORM:APOSITION 62 5.000E+6
indicating the cursor position is 625 MHz.
2-242 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English